33 32 160 Removing and installing/replacing compression strut for rear axle carrier
WARNING: This page is about a different car, the 2016 BMW Z4, 2015 BMW Z4, and 2014 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
IMPORTANT:
Observe safety instructions for raising the vehicle
Driving without the compression strut is not permitted!
Driving without the compression strut is not permitted!
Necessary preliminary tasks:
- Remove exhaust system. See REMOVING COMPLETE EXHAUST SYSTEM (N20)REMOVING COMPLETE EXHAUST SYSTEM (N54) .
- Remove tunnel thermal insulation
IMPORTANT:
Risk of damage!
Support rear axle carrier at front middle with workshop jack.
Release nuts and remove compression strut.
Secure rear axle carrier by screwing on nuts.
Installation:
Replace self-locking nuts.
Tightening torque 33 32 7AZ .