33 32 077 Removing and installing/replacing top right control arm

WARNING: This page is about a different car, the 2016 BMW Z4, 2015 BMW Z4, and 2014 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

31 5 220

NOTE: If the upper control arm is detached from the rear axle carrier/trailing arm, it is necessary after reinstallation to carry out a wheel/chassis alignment check.

Necessary preliminary tasks:

Remove RIGHT OUTPUT SHAFT from rear differential and tie back
Remove COIL SPRING

Release stabilizer on upper control arm.

Tightening torque 33 55 2AZ .

Fig 1: Identifying Stabilizer On Upper Control Arm

G06910299

Courtesy of BMW OF NORTH AMERICA, INC.

Release nut (1) and remove screw.

Tightening torque 33 32 5AZ .

Fig 2: Identifying Control Arm Nut

G06910300

Courtesy of BMW OF NORTH AMERICA, INC.

Release bolt (1) on rear axle carrier and unscrew towards rear.

Remove upper control arm at side.

Fig 3: Identifying Bolt On Rear Axle Carrier

G06910301

Courtesy of BMW OF NORTH AMERICA, INC.

Installation:

Tighten control arm on rear axle carrier in normal position.

Tightening torque 33 32 6AZ .

Adjusting normal position:

IMPORTANT: Coil spring must not be fitted yet!

Press wheel carrier upwards with special tool 31 5 220 and workshop jack up to dimension A.

Dimension A = middle of wheel hub to top edge of wheel arch

Fig 4: Pressing Wheel Carrier Upwards Using Special Tool (31 5 220)

G06910302

Courtesy of BMW OF NORTH AMERICA, INC.

Conventional chassis/suspension:

A = 361 mm

EDC suspension:

A = 351 mm

After installation:

Perform CHASSIS ALIGNMENT CHECK