33 52 000 Removing and installing/replacing rear left or right shock absorber
Installation note:
- All screws, nuts, bolts and hose clamps removed during the repair must be replaced.
- Retaining elements on chassis and suspension and steering parts must be replaced.
Necessary preliminary tasks:
- Remove REAR WHEEL
- Remove LUGGAGE COMPARTMENT WHEEL ARCH PANEL
Version with VDC shock absorber:
- Unlock and disconnect plug connection and expose line to shock absorber
Danger of injury!
Failure to comply with the following instructions may result in the vehicle slipping off the lifting platform, which may result in critical injuries.
When supporting components, make sure that
- the vehicle can no longer be raised or lowered
- the vehicle does not lift off the locating plates on the lifting platform
Support trailing arm with a workshop jack (1).
Release screw.
Tightening torque 33 52 3AZ .
Installation note:
Thrust washer (2) on rubber mount must point to screw head.
Tighten bolt in NORMAL POSITION .
Unscrew nuts (1).
Remove shock absorber with support bearing from below.
Installation note:
Replace flat seal (between support bearing and body).
Replace self-locking nuts.
Tightening torque 33 52 2AZ .
Replacement:
Remove SUPPORT BEARING .
Remove or pull off disc (1), shim, auxiliary absorber (2) with protective tube (3) of the shock absorber (4).
Installation note:
Check auxiliary absorber (2) and protective tube (3) for damage and replace if necessary.
After installation:
- Check that output shaft is correctly seated in rear axle final drive.