33 00... Rear axle: wheel/chassis alignment check must be carried out after the following work
WARNING: This page is about a different car, the 2016 BMW Z4, 2015 BMW Z4, and 2014 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.
A WHEEL/CHASSIS ALIGNMENT CHECK must be carried out after the following work:
- Release of following screw/bolt connections:
- Bearing block to trailing arm/body
- Upper control arm to trailing arm
- Lower control arm to trailing arm
- Replacement of following parts:
- Rear axle carrier
- Lower control arm
- Trailing arm/rubber mount/bearing block
- Upper control arm