33 32 671 Replacing one rubber mount in the upper control arm (control arm removed)

WARNING: This page is about a different car, the 2016 BMW Z4, 2015 BMW Z4, and 2014 BMW Z4. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

33 3 351
33 3 352

Press rubber mount with special tools 33 3 351 and 33 3 352 out of upper control arm.

Fig 1: Pressing Out Rubber Mount Using Special Tools (33 3 351 And 33 3 352)

Courtesy of BMW OF NORTH AMERICA, INC.

Place new rubber mount at chamfered end of control arm bore. Here, longer collar (A = 17 mm) of rubber mount must point upwards.

Press in rubber mount with special tools 33 3 351 and 33 3 352 until flush.

Fig 2: Pressing In Rubber Mount Using Special Tools (33 3 351 And 33 3 352)

Courtesy of BMW OF NORTH AMERICA, INC.

After installation:

Perform CHASSIS ALIGNMENT CHECK