Section 78 (Front Wheel Suspension - Removal, Replacement And Installation (644 Body))
WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.
- Front Axle CROSSMEMBER, Control Arm (Aw55-50/51SN; 2001-2004)
- Control Arm And Control Arm Bushings, Replacing
- Notes
- Remove the Control Arm From the Cross Member
- Control Arm From Ball Joint, Removing
- Wheel Spindle Ball Joint, Check
- Ball Joint Rubber Ring, Replacing
- Control Arm Rear Bushing, Replacing
- Press Out the Front Bushing From the Control Arm
- Install the Front Bushing In the Control Arm
- Install the Control Arm
- Control Arm, Installing
- Replacing the Cross Member
- Preparations
- Remove the Lateral Strut
- Removing the Central Front - Rear Member
- Removing the Front Exhaust Pipe
- Removing the Steering Gear Housing From the Cross Member
- Removing the Anti-Roll Bar From the Control Arms
- Removing the Cross Member
- Transferring the Anti-Roll Bar
- Installing the Cross Member
- Installing the Steering Gear Housing
- Installing the Pipe Bracket
- Installing the Exhaust Pipe
- Installing the Central Front-Rear Member
- Installing the Anti-Roll Bar On the Control Arms
- Installing the Lateral Strut
- Installing the Air Baffle
- Control Arm And Control Arm Bushings, Replacing
- Front Axle CROSSMEMBER, Control Arm (M56; 2004)
- Front Suspension (2000)
- Control Arm And Control Arm Bushings, Replacing
- Replacing the Cross Member
- Preparations
- Remove the Central Front-Rear Member
- Remove the Front Exhaust Pipe
- Disconnect the Gear Selector Lever From the Transmission
- Remove the Steering Gear Housing From the Cross Member
- Remove the Control Arms From the Anti-Roll Bar
- Remove the Control Arm From the Cross Member
- Remove the Cross Member
- Replace the Anti-Roll Bar On the Cross Member
- Install the Cross Member
- Secure the Steering Gear Housing On the Cross Member
- Reinstall the Gear Selector Lever In the Transmission
- Install the Front Exhaust Pipe
- Install the Central Front-Rear Member
- Install the Control Arm
- Secure the Control Arms On the Anti-Roll Bar