Installing the Central Front-Rear Member

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Central Front-Rear Member

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

the member on the front and rear engine mountings
the four screws for the central front-rear member.

NOTE: Note the positions of the rubber element and washers.

Tighten to 70 Nm .

Tighten:

the screws in the engine mountings. Tighten to 55 Nm
the heat deflector plate for the rear engine mounting. Tighten to 10 Nm .