Installing the Anti-Roll Bar On the Control Arms

WARNING: This page is about a different car, the 2004 Volvo S40, 2003 Volvo S40, 2002 Volvo S40, 2001 Volvo S40, and 2000 Volvo S40. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Removing/Installing Anti-Roll Bar From Control Arms

Courtesy of VOLVO CARS OF NORTH AMERICA.

Install:

the anti-roll bar on the control arms
new nuts for the ball joints.

Tighten the nut. First lock the ball joint using a Torx wrench (TX30). Then tighten the nut. Tighten to 50 Nm .