Section 54 (Hydraulic-Vacuum-Hydraulic Brakes - Removal, Replacement And Installation)
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
- Brake Controls (4T65EV, L. H. D; 1999-2005)
- Brake Controls (4T65EV-Gt, L. H. D; 1999-2006)
- Brake Controls (Aw50/51 AWD, L. H. D; Aw55-50/51SN, L. H. D; 2004-2006)
- Brake Pipe And Connections (1999-2006)
- Brake hose front, replacing
- Brake hose rear, replacing
- Brake pipe master cylinder/ABS unit, replacing
- Brake pipe, rear wheel, replacing
- Replacing the brake pipe between the hydraulic unit, front wheel and junction
- Preparation
- Preparations when replacing brake pipes (applies to all brake pipes)
- Replacing the front left brake pipe
- Replacing the front right brake pipe
- Replacing the front-rear brake pipe to the rear junctions
- Clean around the brake pipe on the ABS hydraulic modulator. Remove the brake pipe from the ABS hydraulic modulator and holder
- Remove the brake pipe from its clips by the side member
- Remove the brake pipe from its clips
- Install the new brake pipe
- Installing the brake pipe, continued
- Install the integrated relay/fusebox and the connector for the ABS unit
- Master Cylinder, Brake Booster (1999-2006)
- Master Cylinder, Brake Booster (B5254T2; 2004-2006)
- Master Cylinder, Brake Booster (B6284T; 1999-2001)
- Master Cylinder, Brake Booster (B6294S; 2000-2001)
- Master Cylinder, Brake Booster (B6294S2; B6294T; 2002-2006)
- Master Cylinder, Brake Booster (B6304S3; 1999)
- Master Cylinder, Brake Booster (L. H. D; 1999-2006)
- Brake Fluid Reservoir, Replacing
- Master cylinder, replacing
- Power brake booster, replacing
- Preparation
- Removal
- Installation
- Install the power brake booster
- Install the push rod for the power brake booster and the retaining clip on the brake pedal
- Install the master cylinder
- Install the connectors and vacuum hose
- Install the ABS unit and the bracket
- Install the brake pipes in the master cylinder and in the hydraulic modulator
- Install the cross member
- Checking the power brake booster