Install the brake pipe and the bracket
WARNING: This page does not describe the selected car, but rather 8 other vehicles, including the 2006 Volvo S80, 2005 Volvo S80, 2004 Volvo S80, 2003 Volvo S80, and 2002 Volvo S80. However, it is still accessible from the selected car via links, so may be relevant.
Install:
- the brake pipe to the brake hose (1) at the bracket. Tighten to 17 Nm
- the brake pipe in its clips
- the bracket in its mounting (2). Tighten to 25 Nm .
NOTE:
The brake pipe must not
be in contact with the car body. Ensure that the brake hose is not
twisted. If necessary alter the hose at the other end (brake pipe end). If the brake hose is twisted it may rub against the tire, rim or wheel arch. This could cause the circuit to fail.
Remove the pedal jack.
Fill and bleed the brake system
See Brake system, bleeding (using bleeding unit)
Pressure test the brake system
See Pressure test the brake system
Checking for air in the brake system and for brake fluid leakage
See Checking for air in the brake system and for brake fluid leakage