Section 10 (Transmission System (Controls & Housing - Service Information - 6-Speed Manual - 02Q))
WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
- 34 Controls, Housing
- Bevel Box
- Selector Mechanism
- Selector Mechanism Installation Position
- Overview - Gearshift Knob And Cover
- Overview - Selector Mechanism
- Gearshift Knob, Removing And Installing
- Selector Mechanism, Removing And Installing
- Notes
- Removing
- Installing
- Notes
- With The Selector Relay Lever Removed: Pry The Selector Cable Retainer Out Of The Selector Relay Lever.
- Installing The Selector Cable Retainer On The Relay Lever
- Removing The Cable Retainer From The Gearshift Cable And Selector Cable
- Shift Mechanism, Installing
- Cable Retainer Allocation
- Selector Lever/Relay Lever Installed Position
- Installing The Transmission Shift Lever
- Relay Lever: Lubricate The Following Areas Very Carefully When Installing.
- Gearshift Lever: Lubricate The Following Areas Very Carefully When Installing.
- Tightening Specifications
- Selector Mechanism, Adjusting
- Selector Mechanism, Checking
- Selector Shaft Seal, Replacing
- Transmission, Removing And Installing
- Assembly Mounts
- Front Axle Differential Lock
- Transmission, Transporting
- Transmission, Disassembling And Assembling
- Schematic Overview - Transmission
- Overview - Transmission
- Overview - Transmission Housing And Gearshift Mechanism
- Overview - Shift Unit
- Overview - Input Shaft, Output Shafts, Differential, Gearshift Rods
- Overview - Shift Forks
- Gearshift Shaft Seal, Replacing
- Transmission, Disassembling And Assembling
- Notes
- Transmission, Disassembling
- The Locking Ring -A- Has Been Discontinued Together With The Plastic Cover For The Input Shaft.
- Transmission, Assembling
- The Circlip -1- For The Grooved Ball Bearing/Input Shaft -2- Must Be Re-Examined On Transmissions With Reinforcements:
- Cover Differentiation
- Allocation
- Metal Cover
- Plastic Cover
- AWD Transmission
- Tightening Specifications
- Transmission Housing And Clutch Housing
- Overview - Transmission Housing
- Overview - Clutch Housing
- Transmission Housing, Servicing
- Notes
- Removing The Cover A
- Installing The Cover
- Removing The Locking Elbow For The Gearshift Shaft
- Installed Position: Locking Elbow
- Drive Lock Elbow Arrow For Selector Shaft In Up To Tool Stop.
- Removing The Shift Rod Bearing Bushing
- Installing The Shift Rod Bearing Bushing All The Way Onto The Tool
- Removing The Retaining Sleeve A From The Transmission Housing
- Removing The Retaining Sleeve On A Transmission Not Disassembled Using The 10-15.
- Lock Sleeve Differentiation
- Removing The Reverse Shaft Needle Sleeve From The Transmission Housing
- Installing The Needle Sleeve A Into The Transmission Housing
- Removing The Selector Shaft Bearing Bushing
- Installing The Gearshift Shaft Bearing Bushing A All The Way Onto The Tool
- Removing The Plug 1
- Installing The Plug 1
- Clutch Housing, Servicing
- Securing On Engine And Transmission Holder
- Transmission Fluid
- Manual Transmission Characteristics For Oil Filling
- Transmission Fluid Level, Checking
- Fluid Filler Or Drain Plug Tightening Specification
- Special Tools