Transmission, Removing, Diesel Vehicles: Notes
WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Engine Support Bridge:10-222A
- Engine/Gearbox Support Shackle (2 pc.):10-222A/12
- Engine Support - Adapter 1:10-222A/31-1
- Engine Support - Adapter 2:10-222A/31-2
- Engine Support - Basic Set - Square Pipe:T40091/1
- Engine Support - Basic Set Movable Joint:T40091/3
- Engine Support Supplement Set - Spindle:T40093/3 from Engine Support Supplement Set:T40093B
- Transmission Support:3282
- Engine Support Bridge - Gearbox Adapter:10-222A/29
- Transmission Support - Mounting Plate 33:3282/33
- Support Elements for transmission (determine when mounting the Mounting Plate on the Transmission Support)
- Transmission Support Jig:3336 to transport the transmission.
- Torque Wrench 1331 5-50 Nm :VAG1331
- Torque Wrench 1332 40-200 Nm :VAG1332
- Engine and Gearbox Jack:VAS6931
- Engine Support Brackets:T40093/3-6
- Slide Hammer Set - Adapter 40: VW771/40 from the Slide Hammer Set: VW771
- Hose Clamps - Up To 25 mm:3094
- Engine Bung Set:VAS6122
- M10 x 20 hex bolt
- Grease for Clutch Plate Shaft Splines
-- If the Engine Support Bridge:10-222A does not yet have a hole with an -arrow- marked on it, do so now.
- Dimension -a- = 225 mm
- Hole diameter = 12.5 mm
CAUTION:
This procedure contains mandatory replaceable parts. Refer to component overview prior to starting procedure.
Mandatory Replacement Parts
- Nut - Selector Lever to Shift Lever Shaft with Shift Lever Cover
- Lock Washer - Cable Retainer to Selector Lever
- Lock Washer - Cable Mounting Bracket to Cable Retainer
- Bolt - Pendulum Support to Transmission
- Bolt - Transmission Bracket to Transmission