Overview - Clutch Housing
WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
- Bearing Bushing
- Replace after removing
- For the selector rods
- Removing. Refer to Removing the Shift Rod Bearing Bushing .
- Installing. Refer to Installing the Shift Rod Bearing Bushing All the Way onto the Tool .
- Needle Sleeve
- Replace after removing
- For the reverse shaft
- Removing. Refer to Removing the Needle Sleeve from the Clutch Housing .
- Installing. Refer to Installing the Needle Sleeve A into the Clutch Housing .
- Alignment Sleeve
- Quantity: 2
- Clutch Housing
- When replacing: adjust the output shafts and differential. Refer to ADJUSTMENT OVERVIEW
- Cap
- Not on all clutch housings
- Input Shaft Seal
- Replacing. Refer to INPUT SHAFT SEAL, REPLACING .
- Seal
- For the right flange shaft
- Replacing. Refer to RIGHT SEAL, REPLACING .
- Washer
- For the differential
- Installed position: shoulder on inner diameter faces toward seal -item ) OVERVIEW - CLUTCH HOUSING - Seal
- Outer Race/Tapered Roller Bearing
- For the differential
- Removing and installing. Refer to DIFFERENTIAL, DISASSEMBLING AND ASSEMBLING .
- When replacing: adjust the differential. Refer to DIFFERENTIAL, ADJUSTING
- Oil Deflector Ring
- Installed position: shoulder at hole points toward output shaft
- Outer Race/Tapered Roller Bearing
- For 1st to 4th gear output shaft
- Removing and installing. Refer to 1ST TO 4TH GEAR OUTPUT SHAFT, DISASSEMBLING AND ASSEMBLING .
- Adjust, if output shaft for 1st to 4th gear is replaced. Refer to OUTPUT SHAFT, ADJUSTING .
- Outer Race/Tapered Roller Bearing
- Output Shaft, 5th, 6th and Reverse Gears
- Removing and installing. Refer to OUTPUT SHAFT, 5TH, 6TH AND REVERSE GEARS, DISASSEMBLING AND ASSEMBLING .
- When replacing: adjust output shaft for 5th/6th and reverse gears. Refer to OUTPUT SHAFT, 5TH, 6TH AND REVERSE GEARS, ADJUSTING
- Washer
- Output Shaft, 5th/6th and Reverse Gears
- Always 0.65 mm thick
- Cylindrical Roller Bearing
- For the input shaft
- Removing and installing. Refer to INPUT SHAFT, DISASSEMBLING AND ASSEMBLING .
- Magnet
- Held in place by housing joint surface