Selector Mechanism, Adjusting

WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

Connecting Pin:T10027A

Adjusting Requirements

Operating and transfer elements of shift mechanism must be in proper condition.
Shift mechanism must move freely.
The transmission, clutch and clutch mechanism must also be in proper condition.
Transmission in neutral.

-- Remove the air filter housing if the bracket -A- for the selector shaft and the securing mechanism for the shift and selector cables are not accessible.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Vehicles With Turbo Diesel Engine. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING [FOR ENGINE(S) CRUA]
Vehicles With A Gasoline Engine. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING [FOR ENGINE(S) CNSB, CNSA, CXBB, CXBA, CXCB, CXCA]

-- Pull the safety mechanism on the cable retainer for the shift cable and the selector cable all the way forward in direction of -arrow 1- and then lock it to the left in direction of -arrow 2-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Secure The Gearshift Shaft As Follows:

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Push the gearshift shaft down in the direction of -arrow 1-.

-- While press the gearshift shaft down, rotate the bracket -A- in direction of -arrow 3- upward and simultaneously in direction of -arrow 2- press it in until it engages in the gearshift shaft.

-- Remove the boot and, if possible, the noise insulation from the center console. Refer to GEARSHIFT KNOB, REMOVING AND INSTALLING .

Secure The Gearshift Shaft As Follows:

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the gearshift lever in neutral and, if necessary, press the gearshift lever to the left and hold.

-- Guide the :T10027A through the noise insulation -A-, hole -B- and into hole -C-.

It must be possible to move the selector and shift cable -B- in the cable retainers -A-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Turn the safety mechanism on the cable retainer for the shift cable and selector cable all the way to the right in direction of -arrow 1-.

The spring will push the safety mechanism into the starting position in direction of -arrow 2-.

-- Then turn the bracket -A- in the direction of -arrow 2- back into it starting position.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The bracket -A- must get pushed out of the transmission in direction of -arrow 1-.

-- Remove the :T10027A from the noise insulation -A- and the holes -B and C-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the boot and the noise insulation (if equipped). Refer to OVERVIEW - GEARSHIFT KNOB AND COVER .

-- Make sure the gearshift shaft moves easily.

-- Install the air filter housing.

Vehicles With Turbo Diesel Engine

-- Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING [FOR ENGINE(S) CNSB, CNSA, CXBB, CXBA, CXCB, CXCA] and/or AIR FILTER HOUSING, REMOVING AND INSTALLING [FOR ENGINE(S) CRUA] .

Vehicles With Gasoline Engine

-- Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING [FOR ENGINE(S) CNSB, CNSA, CXBB, CXBA, CXCB, CXCA] .