Overview - Drive Axle, Output Shafts, Differential, Gearshift Rods, FWD: Notes
WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
- 1st through 4th Gear Output Shaft
- Disassembling and Assembling. Refer to OVERVIEW - OUTPUT SHAFT .
- Installation position. Refer to Shafts and Gearshift Rods in Transmission Installation location .
- Gearshift Rod with 1st Gear and 2nd Gear Shift Fork
- Installation position. Refer to Shafts and Gearshift Rods in Transmission Installation location .
- Gearshift Rod with 3rd Gear and 4th Gear Shift Fork
- Installation position. Refer to Shafts and Gearshift Rods in Transmission Installation location .
- 5th, 6th and Reverse Gear Output Shaft
- Disassembling and Assembling. Refer to OUTPUT SHAFT, 5TH, 6TH AND REVERSE GEARS, DISASSEMBLING AND ASSEMBLING .
- Installation position. Refer to Shafts and Gearshift Rods in Transmission Installation location .
- Gearshift Rod with 5th Gear and 6th Gear Shift Fork
- Installation position. Refer to Shafts and Gearshift Rods in Transmission Installation location .
- Reverse Gear Shift Fork
- Installation position. Refer to Shafts and Gearshift Rods in Transmission Installation location .
- Input Shaft
- Installation position. Refer to Shafts and Gearshift Rods in Transmission Installation location .
- Disassembling and Assembling. Refer to Shafts and Gearshift Rods in Transmission Installation location .
- Replace grooved ball bearing on drive axle after removing. Refer to OVERVIEW - INPUT SHAFT .
- Thrust Washer
- Place on the reverse shaft
- Reverse Shaft
- Thrust Washer
- Bleeder
- Connect with clutch slave cylinder
- Clutch Housing
- Servicing. Refer to TRANSMISSION HOUSING AND CLUTCH HOUSING .
- Input Shaft Seal
- Replacing. Refer to INPUT SHAFT SEAL, REPLACING .
- O-ring
- Install on the line connection
- Coat with brake fluid before installing
- Clutch Slave Cylinder with Release Bearing
- Bolt
- Replace after removing
- Removing and installing. Refer to OVERVIEW - CLUTCH RELEASE MECHANISM .
- Quantity: 3
- Bolt
- Tightening Specification. Refer to OVERVIEW - DIFFERENTIAL .
- Right Flange Shaft
- With pressure spring and tapered ring
- Removing and installing. Refer to RIGHT SEAL, REPLACING .
- Assembling. Refer to OVERVIEW - DIFFERENTIAL .
- Differential
- Disassembling and Assembling. Refer to OVERVIEW - DIFFERENTIAL .