Overview - Transmission Housing And Gearshift Mechanism
WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- Removing and installing. Refer to OVERVIEW - DIFFERENTIAL .
- Left Flange Shaft
- With pressure spring and tapered ring
- Removing and installing. Refer to LEFT SEAL, REPLACING .
- FWD, Assembling. Refer to OVERVIEW - DIFFERENTIAL, FWD .
- AWD, Assembling. Refer to OVERVIEW - DIFFERENTIAL, AWD AND FWD WITH FRONT AXLE DIFFERENTIAL LOCK .
- Circlip
- For the metal cover
- Not used in plastic covers
- Cap
- Replace after removing
- Made of metal or plastic. Refer to TRANSMISSION, DISASSEMBLING AND ASSEMBLING .
- Secured with metal locking ring
- Without plastic locking ring
- Circlip
- For the grooved ball bearing/input shaft. Refer to OVERVIEW - INPUT SHAFT .
- Back-Up Lamp Switch -F4-
- 20 Nm
- Seal
- Not installed on all transmissions
- If equipped, replace after removing
- Oil Drain Plug
- Tightening Specification. Refer to FLUID FILLER OR DRAIN PLUG TIGHTENING SPECIFICATION .
- Seal
- Replace after removing
- Bolt
- 6 Nm
- Transmission Neutral Position Sensor -G701-
- For vehicles with the Start/Stop System
- Locking Bolt
- Metal locking bolt: 45 Nm
- Plastic locking bolt: 30 Nm
- Replace locking bolt after removing
- For the selector shaft
- Metal or plastic locking bolt
- Bolt
- 15 Nm +180°
- Replace after removing
- M9 aluminum bolt
- Bolt
- 15 Nm +180°
- Replace after removing
- M9 aluminum bolt
- Gearshift Unit
- (Gearshift shaft with gearshift cover). Refer to OVERVIEW - SHIFT UNIT .
- Bolt
- 20 Nm
- Replace after removing
- O-ring
- Replace after removing
- Clutch Housing
- Servicing. Refer to TRANSMISSION HOUSING AND CLUTCH HOUSING .
- Transmission Housing
- Servicing. Refer to TRANSMISSION HOUSING AND CLUTCH HOUSING .