Selector Shaft Seal, Replacing

WARNING: This page is about a different car, the 2017 Volkswagen GTI, 2016 Volkswagen GTI, 2015 Volkswagen Golf, and 2015 Volkswagen GTI. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

Press Piece - Shift Rod/Alternator:VW423
Puller - Crankshaft/Power Steering Seal:T20143/1
Sealing Grease

-- Remove transmission shift lever and relay lever. Refer to OVERVIEW - SELECTOR MECHANISM .

NOTE:

If it is not possible to remove the relay lever through the transmission bracket, then remove the sliding shoe from the gearshift lever.

-- Remove the gearshift lever from the gearshift shaft.

-- Remove the seal using the :T20143/1

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Lightly oil the new gasket on the outer edge.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Fill the area between the sealing lip and dust lip -Arrow- halfway with Sealing Grease.

-- Drive in the seal using the :VW423 .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Install the gearshift lever and relay lever. Refer to OVERVIEW - SELECTOR MECHANISM .