Section 41 (Electric Powertrain - Testing & Troubleshooting (Hybrid))
WARNING: This page is about a different variant/trim than selected.
- Description & Operation
- Circuit Diagram
- Component Location Index
- Connector View
- Calibration Correction
- Inspection
- Rewrite
- Service Procedure
- Coolant Replacement and Check (Electric Powertrain)
- Electric Powertrain Service Precautions
- General Information
- Preparation items
- Precautions when Working on High Voltage Areas
- Updating Control Units
- Collision Shutoff History Clear Command
- Other Precautions
- No-Load Charging Procedure
- Turning Off and On Power to the High Voltage Circuit
- Disconnecting and Reconnecting the Connector
- How to Cable Connector Bolt Replacement
- System Warning/Indicator Index
- Symptom Troubleshooting
- Electric Powertrain Symptom Troubleshooting - 12 volt charging system indicator comes on faintly, no DTCs set
- Electric Powertrain Symptom Troubleshooting - 12 volt charging system indicator never comes on, no DTCs set
- Electric Powertrain Symptom Troubleshooting - 12 volt charging system indicator stays on, no DTCs set
- Electric Powertrain Symptom Troubleshooting - POWER SYSTEM indicator never comes on, no DTCs set
- Electric Powertrain Symptom Troubleshooting - POWER SYSTEM indicator stays on, no DTCs set
- Electric Powertrain Symptom Troubleshooting - The message (High Voltage Battery Charge Too Low, Vehicle Cannot Start) is indicated on the multi-information display
- Symptom Troubleshooting Index
- Symptom Troubleshooting Index for Viewer
- 12 volt charging system indicator comes on faintly, no DTCs set
- 12 volt charging system indicator never comes on, no DTCs set
- 12 volt charging system indicator stays on, no DTCs set
- HDS does not communicate with the Electric Powertrain System
- POWER SYSTEM indicator never comes on, no DTCs set
- POWER SYSTEM indicator stays on, no DTCs set
- The word (High Voltage Battery Charge Too Low, Vehicle Cannot Start) is indicated on the multi-information display
- Vehicle does not go into READY TO DRIVE mode, and HDS does not communicate with the PCM (POWER SYSTEM indicator comes on and stays on)
- Vehicle will not operate on either electric motor or gasoline engine (POWER SYSTEM indicator works OK, no DTCs set, immobilizer indicator stays on or flashes)
- Test
- DLC Troubleshooting