Collision Shutoff History Clear Command

WARNING: This page is about a different variant/trim than selected.

When the battery condition monitor module receives a collision detection signal (CDS) from the SRS unit, the battery condition monitor module updates the collision shutoff history, and stores it in the nonvolatile memory located inside the module. The battery condition module monitor stops supplying power to the high-voltage circuits disrupting the control signal to be sent to the high-voltage contactor inside the battery module the next time the system is being turned on. To resume power supply to the high-voltage circuits, the collision shutoff history needs to be cleared. Do the following procedures to clear the collision shutoff history.

1. Check the battery high voltage wires (orange coated) for damage. If any damage is found, replace the damaged wire harness or component, then go to step 2.

2. Connect the HDS to the data link connector (DLC)

3. Make sure the HDS communicates with the vehicle and the Electric Powertrain system. If it doesn't, go to the DLC circuit troubleshooting

4. Select the Electric Powertrain system with the HDS.

5. Clear the DTC with the HDS while the engine is stopped.