Section 1201 (Fuel Injection System [CAUA] (Coupe))
WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- 24 Fuel Injection System
- General Information
- Description And Operation
- Magnesium
- Plastic
- Component Location Overview
- Right Side Of The Engine Compartment
- Left Side Of The Engine Compartment
- Location Engine Control Module (ECM) J623
- Fuel Pump (FP) Control Module J538 1
- Relay And Fuse Carrier In Left E-Box Plenum Chamber
- Throttle Position (TP) Sensor G79 And Accelerator Pedal Position Sensor 2G185
- Installation Location, Right Cylinder Bank 1 Oxygen Sensors
- Installation Location, Left Cylinder Bank 2 Oxygen Sensors
- Location Engine Speed (Rpm) Sensor G28 Arrow
- Intake Air Switch-Over Valve N335 2
- Location On Right Cylinder Bank 1
- Location On Left Cylinder Bank 2
- Component Location View From Inside From Right Cylinder Head
- Component Location View From Inside From Left Cylinder Head
- Component Location Front On Engine
- Installation Location: At The Front On The Engine (Running Change In My 2009)
- Location Of High Pressure Pumps
- Evaporative Emission (EVAP) Canister Purge Regulator Valve N80 1
- Air Filter Assembly Overview
- Plastic Intake Manifold, From My 2009 Assembly Overview
- High Pressure Pump Assembly Overview
- Oxygen Sensors Assembly Overview
- Specifications
- Diagnosis And Testing
- Removal And Installation
- Magnesium
- Plastic
- Engine Cover
- Air Filter Element
- Lower Section Of The Air Filter
- Mass Air Flow Sensor
- Fuel Pressure Sensor
- High Pressure Pump
- High Pressure Lines, Installing
- Heated Oxygen Sensor In Front Of Catalytic Converter And Oxygen Sensor Behind Three Way Catalytic Converter, Cylinder Bank 1
- Heated Oxygen Sensor 2 In Front Of Catalytic Converter And Oxygen Sensor 2 Behind Three Way Catalytic Converter, Cylinder Bank 2
- Engine Control Module
- Special Tools