Intake Manifold Assembly Overview: Notes
WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- 9 Nm
- Intake Flap Motor -V157-
- Beginning with MY 2009, the Variable Intake Manifold Runner Motor -V157- has become the Intake Manifold Tuning Valve -N316-
- Bolt
- 9 Nm
- Variable Intake Manifold Runner Motor -V183-
- Beginning with MY 2009, the Variable Intake Manifold Runner Motor -V183- has become the Intake Manifold Tuning Valve -N156-
- Circlip
- Bolt
- 2.5 Nm
- Intake Manifold Runner Position Sensor -G336-
- Right cylinder bank
- After replacing, perform "Adaptation" in "Guided Fault Finding " Vehicle Diagnostic, Testing, and Information System:VAS 5051B .
- Gasket
- Replace if damaged
- Open side faces Intake Manifold Runner Position Sensor -G336-
- Intake manifold
- Removing and installing, refer to INTAKE MANIFOLD
- O-ring
- Replace
- Intake tube
- With crankcase housing ventilation connection
- Bolt
- 9 Nm
- Throttle Valve Control Module -J338-
- After replacing, perform "Adaptation" in "Guided Fault Finding " Vehicle Diagnostic, Testing, and Information System:VAS 5051B .
- O-ring
- Replace
- O-ring
- Replace
- Bolt
- 9 Nm
- Crankcase housing ventilation pressure regulator valve
- Bracket
- For vacuum hose
- Bolt
- 9 Nm
- Bolt
- 9 Nm
- Bolt
- Tightening Specification and sequence, refer to Figure
- Intake manifold seals
- Replace
- Gasket
- Replace if damaged.
- open side faces Intake Manifold Runner Position Sensor 2 -G512-
- Intake Manifold Runner Position Sensor 2 -G512-
- Left cylinder bank
- After replacing, perform "Adaptation" in "Guided Fault Finding" vehicle diagnostic, testing, and information system:VAS 5051B .
- Bolt
- 2.5 Nm
- Circlips