Intake Manifold: Installing

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Installation is in reverse order of removal, Note The Following:

NOTE:

Replace seals and O-rings.

Secure all hose connections using hose clamps appropriate for the model type.

High Pressure Line Connections Must Not Show Any Signs Of Damage.

-- Pay attention to the locating point -1- when installing the intake manifold gaskets.

Fig 1: Locating Point -1- When Installing Intake Manifold Gaskets

Courtesy of AUDI OF AMERICA, LLC

-- Tighten the intake manifold bolts. Refer Figure.

Fig 2: Identifying Intake Manifold Bolts Removal/Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- High pressure lines, installing HIGH PRESSURE LINES, INSTALLING .