Fuel Pressure Sensor: Installing

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Tighten The Fuel Pressure Sensor -G247-.

Tightening Specifications. Refer to COMPONENT LOCATION OVERVIEW

NOTE:

The High Pressure Line Connectors -Arrows- Must Not Be Damaged.

Do not bend the high pressure line to a different angle.

-- Tighten the high pressure line union nut by hand.

-- Make sure the high pressure line is free of tension.

-- Tighten the 17 mm union nut on the high pressure line with the Torque Wrench:V.A.G 1331 and 17 mm Socket Insert:V.A.G 1331/6 .

Fig 1: Identifying SW 17 Union Nut At Fuel Rail, Torque Wrench V.A.G 1331 And SW 17 Socket V.A.G 1331/6

Courtesy of AUDI OF AMERICA, LLC

Further installation is in reverse order.

-- Install intake manifold.