Engine Control Module: Installing
WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
Install In Reverse Order Of Removal.
-- After that, the Engine Control Module (ECM) -J623- must be equipped with the metal retainer.
-- Clean threaded holes for shear bolts of locking compound residue. Cleaning can be performed with a thread cutter (tap).
-- Always use new shear bolts.
- Tightening Specification: Bolts for the E-box cover: 3.5 Nm
Perform The Following Step After Installing A New Engine Control Module:
-- Activate the engine control module in the "Guided Functions " operating mode under "Replace engine control module" on the Vehicle Diagnosis, Testing and Information System:VAS 5051B .