Section 90 (Propeller Shaft - 212 Chassis)
WARNING: This page does not describe the selected car, but rather 33 other vehicles, including the 2016 Mercedes-Benz E63 S AMG, 2016 Mercedes-Benz E400, 2016 Mercedes-Benz E350, 2016 Mercedes-Benz E300, and 2016 Mercedes-Benz E250. However, it is still accessible from the selected car via links, so may be relevant.
- General Information
- Testing & Repair
- Connect sections of propeller shaft - AR41.10-P-0050-05TX
- Release fitting sleeves on flex disks - AR41.10-P-0050-09TX
- Remove/install propeller shaft - AR41.10-P-0050EW
- Remove/install front axle differential propeller shaft - AR41.10-P-0070EWX
- Measure absolute angle at transmission - AR41.10-P-0085-01PA
- Measure absolute angle at front and rear propeller shafts - AR41.10-P-0085-02T
- Measure absolute angle at rear axle housing - AR41.10-P-0085-03T
- Measure propeller shaft alignment with electronic propeller shaft inclinometer - AR41.10-P-0086CW
- Correcting front inclination angle at transmission - AR41.10-P-0086-03CW
- Correcting center inclination angle at propeller shaft intermediate bearing - AR41.10-P-0086-04CW
- Correcting rear articulation angle at rear axle center assembly - AR41.10-P-0086-05CW
- Read out propeller shaft inclination angles from memory; correct if necessary - AR41.10-P-0086-01R
- Prepare electronic propeller shaft inclinometer - AR41.10-P-0086-02P
- Remove/install propeller shaft intermediate bearing and replace grooved ball bearing - AR41.10-P-0100CW
- Press grooved ball bearing out of rubber mount of propeller shaft, press in - AR41.10-P-0100-02TX
- Press rubber mount with grooved ball bearing onto linkage arm - AR41.10-P-0100-05TX
- Pulling off rubber mount with grooved ball bearing - AR41.10-P-0100-07TX
- Replace centering sleeve - AR41.10-P-0200CW
- Removal of centering sleeve - AR41.10-P-0200-02TX
- Press in guide sleeve - AR41.10-P-0200-03TX
- Test & Adjustment Values
- Maintenance
- Capacities & Specifications
- Torque Specifications
- Special Tools