Section 25 (87 Air Conditioning - Wagon -- 971 - PANAMERA (971))

WARNING: This page is about a different variant/trim than selected.

WM, 870129 Cleaning Refrigerant Circuit
- Tools
- Preliminary Work
  - Preliminary Work For Cleaning Refrigerant Circuit
- Cleaning Refrigerant Circuit
- Subsequent Work
  - Subsequent Work For Cleaning Refrigerant Circuit
WM, 870317 Draining And Filling Refrigerant R134A
- General Warning Notes
  - Warning Notes For Handling Refrigerant
- Technical Values
  - Servicing Equipment
- Draining And Filling In Refrigerant
  - Assembly Work Involving The Refrigerant System
  - General Installation Sequence
WM, 870317 Draining And Filling Refrigerant R1234YF
- Tools
- General Warning Notices
  - Warning Notes For Handling Refrigerant
- Technical Values
  - Air Conditioning Servicing Equipment
- Drain And Fill Refrigerant
  - Assembly Work Involving The Refrigerant System
  - General Installation Sequence
- Filling Contaminated Refrigerant Into A Recycling Bottle For Analysis, Treatment (Or Disposal)
  - Information And Tools
  - Transferring Refrigerant Using A Supercooled Recycling Bottle
- Subsequent Work After Extracting/Disposing Of Contaminated Refrigerant In The Refrigerant Circuit
WM, 871119 Removing And Installing Air Conditioning Control Unit
- Technical Values
- Preliminary Work
- Removing Air Conditioning Control Unit
- Installing Air Conditioning Control Unit
- Subsequent Work
WM, 871155 Replacing Air Conditioning Control Unit
- Technical Values
- Replacing Air Conditioning Control Unit
WM, 871419 Removing And Installing Sun Sensor
- Preliminary Work
- Removing Sun Sensor
- Installing Sun Sensor
- Subsequent Work
WM, 872019 Removing And Installing Servo Motor For Left Side Vent
- Tools
- Technical Values
- Component Information
  - Installation Position Of Servo Motor For Left Side Air Vent
- Preliminary Work
- Removing Servo Motor For Left Side Vent
- Installing Servo Motor For Left Side Vent
- Subsequent Work
WM, 872019 Removing And Installing Servo Motor For Rear Right Temperature Mixing Flap (4-Zone Air Conditioning)
- Tools
- Technical Values
- Component Information
  - Installation Position Of Servo Motor For Rear Right Temperature Mixing Flap
- Preliminary Work
- Removing Servo Motor For Rear Right Temperature Mixing Flap (4-Zone Air Conditioning)
- Installing Servo Motor For Rear Right Temperature Mixing Flap (4-Zone Air Conditioning)
- Subsequent Work
WM, 872019 Removing And Installing Servo Motor For Extended Ventilation Panel
- Tools
- Technical Values
- Component Information
  - Installation Position Of Servo Motor For Extended Ventilation Panel
- Preliminary Work
  - Preliminary Work For Extended Ventilation Panel
- Removing Servo Motor For Extended Ventilation Panel
- Installing Servo Motor For Extended Ventilation Panel
- Subsequent Work
  - Subsequent Work For Extended Ventilation Panel
WM, 872019 Removing And Installing Servo Motor For Right Centre Vent
- Tools
- Technical Values
- Component Information
  - Installation Position Of Servo Motor For Right Centre Vent
- Preliminary Work
- Removing Servo Motor For Right Centre Vent
- Installing Servo Motor For Right Centre Vent
- Subsequent Work
WM, 872019 Removing And Installing Servo Motor For Right Side Air Vent
- Tools
- Technical Values
- Component Information
  - Installation Position Of Servo Motor For Right Side Air Vent
- Preliminary Work
- Removing Servo Motor For Right Side Air Vent
- Installing Servo Motor For Right Side Air Vent
- Subsequent Work
WM, 872019 Removing And Installing Servo Motor For Right Foot Bypass
- Tools
- Technical Values
- Component Information
  - Installation Position Of Servo Motor For Right Foot Bypass
- Preliminary Work
- Removing Servo Motor For Right Foot Bypass
- Installing Servo Motor For Right Foot Bypass
- Subsequent Work
WM, 872019 Removing And Installing Servo Motor For Defroster Flap
- Tools
- Technical Values
- Component Information
  - Installation Position
- Preliminary Work
- Removing Servo Motor For Defroster Flap
- Installing Servo Motor For Defroster Flap
- Subsequent Work
WM, 872019 Removing And Installing Servo Motor For Front Left Temperature Mixing Flap
- Tools
- Technical Values
- Component Information
  - Installation Position Of Servo Motor For Front Left Temperature Mixing Flap
- Preliminary Work
  - Preliminary Work For Servo Motor For Front Left Temperature Mixing Flap
- Removing Servo Motor For Front Left Temperature Mixing Flap
- Installing Servo Motor For Front Left Temperature Mixing Flap
- Subsequent Work
  - Subsequent Work For Servo Motor For Front Left Temperature Mixing Flap
WM, 872019 Removing And Installing Servo Motor For RECIRCULATION Flap
- Tools
- Technical Values
- Component Information
  - Installation Position Of Servo Motor For Recirculation Flap
- Preliminary Work
- Removing Servo Motor For RECIRCULATION Flap
- Installing Servo Motor For RECIRCULATION Flap
- Subsequent Work
WM, 872019 Removing And Installing Servo Motor For Rear Left Temperature Mixing Flap (4-Zone Air Conditioning)
- Tools
- Technical Values
- Component Information
  - Installation Position Of Servo Motor For Rear Left Temperature Mixing Flap
- Preliminary Work
- Removing Servo Motor For Rear Left Temperature Mixing Flap (4-Zone Air Conditioning)
- Installing Servo Motor For Rear Left Temperature Mixing Flap (4-Zone Air Conditioning)
- Subsequent Work
  - Subsequent Work For Servo Motor For Rear Left Temperature Mixing Flap
WM, 872019 Removing And Installing Servo Motor For Bypass Heat Flap In Front Left FOOTWELL
- Tools
- Technical Values
- Component Information
  - Installation Position Of Servo Motor For Bypass Heat Flap In Front Left Footwell
- Preliminary Work
  - Preliminary Work For Servo Motor For Bypass Heat Flap In Front Left Footwell
- Removing Servo Motor For Bypass Heat Flap In Front Left FOOTWELL
- Installing Servo Motor For Bypass Heat Flap In Front Left FOOTWELL
- Subsequent Work
  - Subsequent Work For Servo Motor For Bypass Heat Flap In Front Left Footwell
WM, 872019 Removing And Installing Servo Motor For Front Right Temperature Mixing Flap
- Tools
- Technical Values
- Component Information
  - Installation Position Of Servo Motor For Front Right Temperature Mixing Flap
- Preliminary Work
- Removing Servo Motor For Front Right Temperature Mixing Flap
- Installing Servo Motor For Front Right Temperature Mixing Flap
- Subsequent Work
WM, 872019 Removing And Installing Servo Motor For Right FOOTWELL Outlet Vent
- Tools
- Technical Values
- Component Information
  - Installation Position Of Servo Motor For Right Footwell Outlet Vent
- Preliminary Work
- Removing Servo Motor For Right FOOTWELL Outlet Vent
- Installing Servo Motor For Right FOOTWELL Outlet Vent
- Subsequent Work
WM, 872019 Removing And Installing Servo Motor For Fresh Air/Ram Air Flap
- Tools
- Technical Values
- Component Information
  - Installation Position Of Servo Motor For Fresh Air/Ram Air Flap
- Preliminary Work
  - Preliminary Work For Servo Motor For Fresh Air/Ram Air Flap
- Removing Servo Motor For Fresh Air/Ram Air Flap
- Installing Servo Motor For Fresh Air/Ram Air Flap
- Subsequent Work
  - Subsequent Work For Servo Motor For Fresh Air/Ram Air Flap
WM, 872019 Removing And Installing Servo Motor For Left FOOTWELL Outlet Vent
- Tools
- Technical Values
- Component Information
  - Installation Position Of Servo Motor For Left Footwell Outlet Vent
- Preliminary Work
- Removing Servo Motor For Left FOOTWELL Outlet Vent
- Installing Servo Motor For Left FOOTWELL Outlet Vent
- Subsequent Work
WM, 872019 Removing And Installing Servo Motor For Left Centre Vent
- Tools
- Technical Values
- Component Information
  - Installation Position Of Servo Motor For Left Centre Vent
- Preliminary Work
- Removing Servo Motor For Left Centre Vent
- Installing Servo Motor For Left Centre Vent
- Subsequent Work
WM, 872219 Removing And Installing Air Quality Sensor
- Information
  - Installation Position Of Air Quality Sensor
- Preliminary Work
  - Preliminary Work For Air Quality Sensor
- Removing Air Quality Sensor
- Installing Air Quality Sensor
- Subsequent Work
  - Subsequent Work For Air Quality Sensor
WM, 873419 Removing And Installing Electric Air-Conditioning Compressor
- Tools
- Technical Values
- Information
  - Installation Position Of Electric Air-Conditioning Compressor
- Preliminary Work
  - Preliminary Work For Electric Air-Conditioning Compressor
- Removing Electric Air-Conditioning Compressor
- Installing Electric Air-Conditioning Compressor
- Subsequent Work
  - Subsequent Work For Electric Air-Conditioning Compressor
- Compressor Run-In After Installing A New Air-Conditioning Compressor
WM, 873429 Cleaning Electric Air-Conditioning Compressor
- Tools
- Preliminary Work
  - Preliminary Work For Electric Air-Conditioning Compressor
- Cleaning Electric Air-Conditioning Compressor
  - Warning Notes For Handling Refrigerant
- Subsequent Work
  - Subsequent Work For Electric Air-Conditioning Compressor
WM, 874319 Removing And Installing Compressor/Condenser Line
- Tools
- Technical Values
- Component Information
  - Installation Position Of Compressor/Condenser Line
- Preliminary Work
- Removing Compressor/Condenser Line
- Installing Compressor/Condenser Line
- Subsequent Work
WM, 874419 Removing And Installing Evaporator/Condenser Line
- Tools
- Technical Values
- Component Information
  - Installation Position Of Evaporator/Condenser Line
- Preliminary Work
- Removing Evaporator/Condenser Line
- Installing Evaporator/Condenser Line
- Subsequent Work
WM, 874519 Removing And Installing Compressor/Evaporator Line
- Tools
- Technical Values
- Component Information
  - Installation Position Of Compressor/Evaporator Line
- Preliminary Work
- Removing Compressor/Evaporator Line
- Installing Compressor/Evaporator Line
- Subsequent Work
WM, 875019 Removing And Installing Condenser
- Technical Values
- Information
  - Installation Position Of Condenser
- Preliminary Work
  - Preliminary Work For Condenser
- Removing Condenser
- Installing Condenser
- Subsequent Work
  - Subsequent Work For Condenser
WM, 875819 Removing And Installing Temperature Sensor
- Component Information
  - Installation Position Of Temperature Sensor
- Preliminary Work
  - Preliminary Work For Temperature Sensor In Dashboard
  - Preliminary Work For Temperature Sensor In Heating/Fresh-Air Unit
- Removing Temperature Sensor
- Installing Temperature Sensor
- Subsequent Work
  - Subsequent Work For Temperature Sensor In Dashboard
  - Subsequent Work For Temperature Sensor In Heating/Fresh-Air Unit
WM, 877019 Removing And Installing Expansion Valve
- Technical Values
- Information
  - Installation Position Of Expansion Valve
- Preliminary Work
  - Preliminary Work For Expansion Valve
- Removing Expansion Valve
  - General Warning Notes For Working On The Air-Conditioning System
- Installing Expansion Valve
- Subsequent Work
  - Subsequent Work For Expansion Valve
WM, 878319 Removing And Installing Pressure Switch (Pressure Sensor)
- Tools
- Technical Values
- Information
  - Installation Position Of Pressure Sensors
- Preliminary Work
  - Preliminary Work For Pressure Sensor
- Removing Pressure Sensor
  - Removing Pressure Sensor In High-Pressure Line (Air-Conditioning Compressor To Condenser)
  - Removing Pressure Sensor In Low-Pressure Line (Expansion Valve To Air-Conditioning Compressor)
- Installing Pressure Sensor
  - Installing Pressure Sensor In High-Pressure Line (Air-Conditioning Compressor To Condenser)
  - Installing Pressure Sensor In Low-Pressure Line (Expansion Valve To Air-Conditioning Compressor)
- Subsequent Work
  - Subsequent Work For Pressure Sensor