Installing Servo Motor For Front Right Temperature Mixing Flap
WARNING: This page is about a different variant/trim than selected.
- Installation is performed in reverse order. Pay particular attention to the following:
Screw in and tighten screws securing servo motor for right front temperature mixing flap to air conditioner > Tightening torque 1.5 Nm (1 ftlb.)
Screw in and tighten screws securing sound box to air conditioner > Tightening torque 1.5 Nm (1 ftlb.)
Screw in and tighten screws securing cover to air conditioner > Tightening torque 1.5 Nm (1 ftlb.)
Tighten clamps for coolant lines > Tightening torque 6 Nm (4.5 ftlb.)
Screw in and tighten screws securing holder for coolant lines to air conditioner > Tightening torque 1.5 Nm (1 ftlb.)