Section 57 (Combination Meter On-Vehicle Service - With Diagnostics)
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
- Service Specifications
- Special Tools
- Combination Meters Diagnostic
- Diagnostic Trouble Code Procedures
- DTC B1200: Odometer Failure
- DTC B1201: Fuel Information Problem
- DTC B1209: Test Mode
- DTC B2463: Rheostat Switch Sticking
- DTC B2464: Meter Information SW sticking - High Contrast Meter
- DTC U0141: ETACS CAN Timeout
- DTC U0164: A/C CAN Timeout
- DTC U0168: WCM/F.A.S.T. CAN Timeout
- DTC U0184: AUDIO CAN Timeout
- DTC U0230: POWER GATE CAN Timeout
- DTC U0245: NAVI/DISP. AUDIO CAN Timeout
- DTC U1000: OSS CAN Timeout
- DTC U1190: No Receive Fault Detect Signal
- DTC U1195: Coding Not Completed
- Trouble Symptom Chart
- Symptom Procedures
- Inspection Procedure 1: Power Supply Circuit Check; Inspection Procedure 2: The Odometer And The Trip Meter Are Not Displayed.; Inspection Procedure 3: No Needle Meters Work.; Inspection Procedure 4: If The Ignition Switch Is Turned To The On Position, The Indicator And Warning Lights Do Not Illuminate Normally
- Inspection Procedure 5: The Speedometer Does Not Work (The Other Meters Work)
- Inspection Procedure 6: The Tachometer Does Not Work (The Other Meters Work)
- Inspection Procedure 7: Tone Alarm Do Not Sound Normally
- Notes
- Technical Description (Comment)
- Notes
- LDW warning tone alarm
- Theft-alarm tone alarm
- Electric steering wheel lock malfunction warning tone alarm (vehicles with OSS)
- OSS-related malfunction warning tone alarm (vehicles with OSS)
- Engine switch reminder tone alarm (vehicles with OSS)
- Keyless operation key reminder tone alarm (vehicles with KOS)/Ignition key reminder tone alarm (vehicles without KOS)
- Light reminder tone alarm
- Door-ajar warning tone alarm
- Freeze warning tone alarm
- Parking brake reminder tone alarm
- Multi information display interrupt display tone alarm
- Meter information switch or rheostat illumination switch < High contrast meter > operation tone alarm
- Turn-signal light tone alarm
- A/T shift cancel tone alarm/Paddle shift cancel prohibition tone alarm, ETACS-ECU function customize tone alarm, A/C operation tone alarm, audio operation tone alarm
- Troubleshooting Hints
- Diagnosis
- Inspection Procedure 8: Fuel Gauge Does Not Work (The Other Meters Work)
- Inspection Procedure 9: The Combination Meter Light Does Not Illuminate Normally Or The Multi-Information Display Is Not Displayed Normally
- Inspection Procedure 10: The Multi-Information Display Screen Cannot Be Changed With The Operation Of The Meter Information Switch
- Inspection Procedure 11: Parking Brake Reminder Tone Alarm Does Not Sound.; Inspection Procedure 12: Brake Warning Light Does Not Illuminate
- Inspection Procedure 13: Seat Belt Reminder Function Does Not Work Normally
- Inspection Procedure 14: The Combination Meter And Instrument Panel Illumination Does Not Illuminate Normally
- Service Data
- Actuator Test Table
- Special Function Table
- Check Procedure For Each Multi Information Display Screen - High Contrast Meter
- Check At Combination Meter Terminals
- On-Vehicle Service
- Tachometer Check
- Notes
- Fuel Level Sensor Check
- Service Reminder Function Set
- Combination Meter
- Meter Information Switch