Check At Combination Meter Terminals
WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
| Terminal No. | Terminal code | Check item | Check condition | Normal condition |
|---|---|---|---|---|
| 1 | B+B | ECU power supply (battery) | Always | Battery positive voltage |
| 2 | IG1 | ECU power supply (Ignition switch: IG1) | Ignition switch: ON | Battery positive voltage |
| Ignition switch: OFF | 1 V or less | |||
| 3 | MODE | Multi information display switch input | Multi information display switch: ON | 1 V or less |
| Multi information display switch: OFF | Battery positive voltage | |||
| 4 | BRK | Parking brake switch input | Parking brake switch: ON | 1 V or less |
| Parking brake switch: OFF | Battery positive voltage | |||
| 5 | SBDS | Seat belt switch (driver's side) input | Seat belt switch (driver's side): ON | 1 V or less |
| Seat belt switch (driver's side): OFF | Battery positive voltage | |||
| 6 to 12 | - | - | - | - |
| 13 | GND | Ground (sensor) | Always | 1 V or less |
| 14 | CANH | CAN-C-Mid_H | - | - |
| 15 | CANL | CAN-C-Mid_L | - | - |
| 16 | SBAS | Seat belt switch (passenger's side) input | - | - |
| 17 | - | - | - | - |
| 18 | F/G | Input of fuel gauge | Fuel: FULL | Approximately 1 V |
| Fuel: EMPTY | Approximately 8 V | |||
| 19 | BWLP | Seat belt reminder (passenger's side) indicator lamp output | Seat belt switch (passenger's side): ON | Battery positive voltage |
| Seat belt switch (passenger's side): OFF | 1V or less | |||
| 20 | SPEED | Vehicle speed signal output | Vehicle speed: Approximately 40 km/h | Approximately 28Hz |
| Vehicle speed change | In accordance with the vehicle speed, a pulse is generated. | |||
| 21 | GND1 | Ground (ECU) | Always | 1 V or less |
| 22 | PWM | Illumination (-) output | With daytime lighting control | 1 V or less |
| With nighttime lighting control | In accordance with the meter information switch operation, a pulse is generated. | |||
| 23 | ILL+ | Illumination (+) output | With lighting control | Battery positive voltage |
| Without lighting control | 1 V or less (Open) | |||
| 24 | IL+P | Illumination (power supply) | Always | Battery positive voltage |