LEMON Manuals: Even more car manuals for everyone
Home >> Mitsubishi >> 2014 >> Lancer ES Sportback >> Repair and Diagnosis >> External Pages >> Different car >> Section 57 (Combination Meter On-Vehicle Service - With Diagnostics) >> Tachometer Check >> Fuel Level Sensor Check >> < AWD > >> Fuel Level Sensor Float Height

Fuel Level Sensor Float Height

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the fuel pump module (Refer to FUEL PUMP MODULE REPLACEMENT ) < Main >.
  2. Remove the fuel level sensor (Refer to FUEL LEVEL SENSOR (SUB) REPLACEMENT < AWD >) < Sub >.
  3. When float is moved to contact the float arm on the stopper, ensure that stopper positions "F" (height A) and "E" (height B) are within the standard value.
    Fig 1: Identifying Stopper Position Height
    G09666954Courtesy of MITSUBISHI MOTOR SALES OF AMERICA.
    STANDARD VALUE SPECIFICATIONS

    Float position Float height mm (in)
    Main Sub
    Stopper position "F" (height A) 166.2 (6.5) 48.8 ± 3.0 (1.9 ± 0.1)
    Stopper position "E" (height B) 38.8 (1.5) 238.0 ± 3.0 (9.3 ± 0.1)
scientia non olet · About LEMON Manuals