Diagnostic Trouble Code Table

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

During troubleshooting, a DTC associated with other system may be stored when the ignition switch is turned on with connector(s) disconnected. On completion, confirm all systems for DTCs. If DTCs are stored, erase them all.
If the combination meter needs to be replaced as a result of troubleshooting, the current driving distance and elapsed days must be entered into the meter after the replacement in order to be used for service reminder function. Therefore, read "Integrated mileage for reminder," "Integrated days for reminder," "Mileage until Extra reminder," "Months until Extra reminder," and "Current schedule" from the meter before the replacement using the special function of scan tool (M.U.T.-III), and note them. For the operation method of scan tool (M.U.T.-III), refer to HOW TO SET BY OPERATING THE SCAN TOOL (M.U.T.-III) . If "Integrated mileage for reminder" or "Integrated days for reminder" cannot be read from the meter using scan tool (M.U.T.-III), use the following method.
1. For the driving distance for check warning, use the driving distance displayed on the multi information display.
2. For the elapsed days for check warning, calculate the number of elapsed days from the delivery date to the customer (service reminder function start date) and current date.

DIAGNOSTIC TROUBLE CODE TABLE

DTC No.	Diagnostic item
B1200	Odometer failure
B1201	Fuel information problem
B1209	Test mode
B2463	Rheostat switch sticking
B2464	Meter information SW sticking < High contrast meter >
U0100	Engine CAN timeout
U0141	ETACS CAN timeout
U0164	A/C CAN timeout
U0168	WCM/F.A.S.T. CAN timeout
U0184	AUDIO CAN timeout
U0230	Power Gate CAN timeout
U0245	NAVI/DISP.AUDIO CAN timeout
U1000	OSS CAN timeout
U1190	No receive fault detect signal
U1195	Coding not completed