Inspection Procedure 10: The Multi-Information Display Screen Cannot Be Changed With The Operation Of The Meter Information Switch: Diagnosis

WARNING: This page is about a different car, the 2014 Mitsubishi Outlander. However, it is still accessible from the selected car via links, so may be relevant.

STEP 1. Using scan tool (M.U.T.-III), read the combination meter diagnostic trouble code.
Check if DTC No. B2463 < Standard meter > or No. B2464 < High contrast meter > is stored.

CAUTION: To prevent damage to scan tool (M.U.T.-III), always turn the ignition switch to the "LOCK" (OFF) position before connecting or disconnecting scan tool (M.U.T.-III).
1. Connect scan tool (M.U.T.-III). Refer to "HOW TO CONNECT THE SCAN TOOL (M.U.T.-III) ."
2. Turn the ignition switch to the "ON" position.
3. Turn the ignition switch from "LOCK" (OFF) position to "ON" position.
4. Check if DTC is stored.
Q: Is DTC No. B2463 < Standard meter > or No. B2464 < High contrast meter > stored?
1. YES: Follow the relevant DTC procedure (Refer to COMBINATION METERS DIAGNOSTIC ).
2. NO: Go to Step 2.
STEP 2. Check by scan tool (M.U.T.-III) "Special Function"
- Item 2: LCD (AUTO) (Refer to SPECIAL FUNCTION TABLE ).
Q: Is the check result normal?
1. YES: Go to Step 3.
2. NO: Replace the combination meter, and then go to Step 3.
STEP 3. Retest the system.
Check that the multi-information display screen works normally.

Q: Is the check result normal?
1. YES: The procedure is complete.
2. NO: Replace the combination meter.