Section 3494 (Rear Axle - Repair (ACTIVEHYBRID))
WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
- Rear Axle, General
- 33 00... Instructions (chassis components made of aluminium)
- 33.... Layout of shock absorber
- 33 00... Notes on repairing threads
- 33.... Overview of rear axle final drive/output shafts
- 33.... Overview of rear axle support with rubber mounts
- 33.... Overview of steering links
- 00..... Raising vehicle with trolley jack
- 33 00... Rear axle: wheel/chassis alignment check must be carried out after the following work
- 41 00... Repair solution for straight shank/hexagon rivet nut
- Final Drive
- Final Drive With Cover
- Final Drive Mounting
- Output Shafts
- Rear Sub-Frame
- Control Arms And Struts
- 33 32 131 Removing and installing/replacing a steering stub/wheel carrier
- 33 32 153 Removing and installing/replacing front compression strut
- 33 32 051 Removing and installing/replacing left or right push rod/integral link
- 33 32 064 Removing and installing/replacing left or right swinging arm
- 33 32 155 Removing and installing/replacing rear compression strut
- 33 32 125 Replacing a ball joint in lower steering stub / wheel carrier
- 33 32 091 Replacing a control arm
- 33 32 071 Replacing an upper wishbone
- Axle Mounting
- Wheel Bearings
- Shock Absorber
- Stabilizer Bar