33 17 005 Replacing rubber mount for rear final drive unit mounting at rear

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.

Special tools required:

Necessary preliminary tasks:

Remove REAR DIFFERENTIAL

Pull out rubber mount with special tools 33 5 153 , 33 5 152 , 33 5 151 , 33 3 103 and 33 3 104 .

NOTE: Make sure special tool 33 5 152 contacts rear axle support correctly.

Use ratchet ring wrench 33 5 105 .

Fig 1: Pulling Out Rubber Mount With Special Tools

Courtesy of BMW OF NORTH AMERICA, INC.

IMPORTANT: Coat bearing bushing in rear axle carrier and new rubber mount with Circo Light (refer to BMW Parts Service).

Align rubber mount horizontally by way of elongated hole (1).

Fig 2: Identifying Rubber Mount Alignment Elongated Hole

Courtesy of BMW OF NORTH AMERICA, INC.

Insert rubber mount (1) in special tool 33 5 154 .

Draw in rubber mount (1) with special tools 33 5 155 , 33 5 154 , 33 5 156 , 33 3 103 and 33 3 104 as far as it will go.

NOTE: Make sure special tools 33 5 154 and 33 5 156 contact rear axle support correctly.
Use ratchet ring wrench 33 5 105 .

Fig 3: Inserting Rubber Mount In Special Tool (33 5 154)

Courtesy of BMW OF NORTH AMERICA, INC.