33 32 155 Removing and installing/replacing rear compression strut
WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
The rear compression strut will be discontinued as of production date 03/2013.
IMPORTANT:
Observe SAFETY INSTRUCTIONS
for raising the vehicle
Driving without compression struts is not permitted!
Driving without compression struts is not permitted!
Release screw (1).
Tightening torque 33 33 3AZ .
Release screw (3) and remove compression strut (2).
Secure rear axle support by inserting screw (3).
Installation note:
Check threads for damage; if necessary, repair with HELICOIL THREAD INSERTS .
Tightening torque 33 33 1AZ .