LEMON Manuals: Even more car manuals for everyone
Home >> Mini >> 2010 >> Cooper S, 2D Hatchback, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 3494 (Rear Axle - Repair (ACTIVEHYBRID)) >> Final Drive >> 33 10 010 Removing and installing/replacing rear differential >> Assembly sequence

Assembly sequence

WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install rear axle final drive with workshop jack and special tool 33 5 200 in rear axle support
  2. Insert bolts (1) (do not tighten down)
  3. Insert bolt from rear and replace nut (2) (do not tighten down)

    For E72: Insert bolt from rear!

  4. Release tensioning strap, lower special tool 33 5 200 and move away
  5. Tighten down screws (1)

    Tightening torque: 100 Nm

  6. Tighten nut (2)

    Tightening torque: 165 Nm

    Fig 1: Identifying Rear Differential Screws And Nut
    G04794559Courtesy of BMW OF NORTH AMERICA, INC.
scientia non olet · About LEMON Manuals