33 55 000 Removing and installing/replacing rear anti-roll bar
WARNING: This page is about a different car, the 2011 BMW X6 and 2010 BMW X6. However, it is still accessible from the selected car via links, so may be relevant.
Necessary preliminary tasks:
- Remove both ANTI-ROLL BAR LINKS FROM ANTI-ROLL BAR
Release screws (1).
Replacement only: Remove BOTH RUBBER MOUNTS FROM STABILIZER .
Turn anti-roll bar (2) and remove sideways.
Installation:
Check BOTH RUBBER MOUNTS FOR DAMAGE , replace if necessary.
Align stabilizer centrally.
Tightening torque 33 55 1AZ .