Section 2 (Automatic Transmission - 9T50 (M3E) - Diagnostic Information And Procedures)
WARNING: This page is about a different variant/trim than selected.
- Diagnostic Information and Procedures
- DTC P0601, P0602, P0603, P0604, P0606, P062F, P16F3 or P16FB: Control Module
- DTC P0658 or P0659, P2727, P2729, P2730, P2736, P2738, P2739, P2826, P2827, P282F, or P2830: Actuator High Control Circuit/AT Control Solenoid
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Typical Scan Tool Data
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Actions Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Component Testing
- Repair Instructions
- DTC P0707, P0708, P2802, P2803 or P2805: Transmission Range Sensor Circuit
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Typical Scan Tool Data
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Actions Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- DTC P0711, P0712, P0713: Transmission Fluid Temperature Sensor
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Typical Scan Tool Data
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Actions Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Component Testing
- Repair Instructions
- DTC P0716, P0717, P07BF or P07C0: Input Speed Sensor
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Typical Scan Tool Data
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Actions Taken When the DTC Sets
- Conditions for Clearing the DTC
- Diagnostic Aids
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- DTC P0721-P0723, P077C or P077D: Output Speed Sensor
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Typical Scan Tool Data
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Actions Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- DTC P0741, P2817 or P2818: Torque Converter Clutch (TCC) System Stuck Off/Transmission Control Solenoid Valve 8
- DTC P0746 or P0747: Transmission Control Solenoid Valve 1
- DTC P0776 or P0777: Transmission Control Solenoid Valve 2
- DTC P0796 or P0797: Transmission Control Solenoid Valve 3
- DTC P0815, P0816 or P0826: Up and Down Shift Switch Circuit
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Typical Scan Tool Data
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Actions Taken When the DTC Sets
- Conditions for Clearing the DTC
- Diagnostic Aids
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Component Testing
- Repair Instructions
- DTC P0960, P0962, P0963, P0964, P0966, P0967, P0968, P0970, P0971, P2670, P2671, P2718, P2720, P2721, P2812, P2814, P2815, P281B, P281D Or P281E: Transmission Control Solenoid Valve
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Typical Scan Tool Data
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Actions Taken When the DTC Sets
- Conditions for Clearing the DTC
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Component Testing
- Repair Instructions
- DTC P0964, P0966 or P0967: Transmission Control Solenoid Valve 2 Control Circuit
- DTC P0968, P0970 or P0971: Transmission Control Solenoid Valve 3 Control Circuit
- DTC P175E: Transmission Control System - Shift Limiting Active
- DTC P175F: Acceleration Sensor Signal Message Counter Incorrect
- DTC P1761: Up and Down Shift Switch Signal Message Counter Incorrect
- DTC P176B, P176C, P176D or P17D3: Intermediate Speed Sensor Circuit
- Diagnostic Instructions
- DTC Descriptor
- Diagnostic Fault Information
- Typical Scan Tool Data
- Circuit/System Description
- Conditions for Running the DTC
- Conditions for Setting the DTC
- Actions Taken When the DTC Sets
- Conditions for Clearing the DTC
- Diagnostic Aids
- Reference Information
- Circuit/System Verification
- Circuit/System Testing
- Repair Instructions
- DTC P188B: Transmission Range Signal Message Counter Incorrect
- DTC P2670 or P2671: Actuator High Control Circuit Group 2 Voltage
- DTC P2714 or P2715: Transmission Control Solenoid Valve 4
- DTC P2718, P2720 or P2721: Transmission Control Solenoid Valve 4 Control Circuit
- DTC P2723 or P2724: Transmission Control Solenoid Valve 5
- DTC P2727, P2729 or P2730: Transmission Control Solenoid Valve 5 Control Circuit
- DTC P2731-P2733: Transmission Control Solenoid Valve 6
- DTC P2736, P2738 or P2739: Transmission Control Solenoid Valve 6 Control Circuit
- DTC P27A7-P27AE: Transmission Control Solenoid Valve Calibration Incorrect
- DTC P2812, P2814 or P2815: Transmission Control Solenoid Valve 7 Control Circuit
- DTC P281B, P281D or P281E: Transmission Control Solenoid Valve 8 Control Circuit
- DTC P2820 or P2821: Transmission Control Solenoid Valve 9
- DTC P2826 or P2827: Transmission Control Solenoid Valve 9 Control Circuit Voltage
- DTC P282F or P2830: Transmission Control Solenoid Valve 10 Control Circuit Voltage
- Solenoid Valve Characterization Reprogramming
- Symptoms - Automatic Transmission
- Transmission Fluid Level and Condition Check
- Road Test
- Torque Converter Diagnosis
- Torque Converter Stator
- Poor Acceleration at Low Speed - Stator Roller Clutch Freewheels at All Times
- Poor Acceleration at High Speed - Stator Roller Clutch is Locked Up at All Times
- Torque Converter Bearing Noise
- Torque Converter Clutch
- Torque Converter Clutch Shudder
- If Shudder Occurs During TCC Apply, Release and ECCC
- If Shudder Occurs After TCC has Locked
- Torque Converter Vibration Test
- Indexing Torque Converter
- Clutch Plate Diagnosis
- Engine Coolant/Water in Transmission
- Fluid Leak Diagnosis
- Case Porosity Repair
- Bushing and Mating Shaft Inspection
- Noise and Vibration Analysis
- Whine/Growl Noise
- Automatic Transmission Fluid Leaks
- Shift Indicator Indicates Wrong Gear Selection
- No Park
- Harsh Garage Shift
- No Drive in All Ranges
- No Torque Converter Clutch Apply
- No Torque Converter Clutch Release
- No Reverse Gear
- Transmission Service Fast Learn Procedure
- Fluid Pressure High or Low