Repair Instructions
WARNING: This page is about a different variant/trim than selected.
Perform the Diagnostic Repair Verification after completing the repair: Diagnostic Repair Verification
- Automatic Transmission Wiring Harness Replacement
- Manual Shift Detent Lever with Shaft Position Switch Assembly and Park Pawl Actuator Removal - B303 Transmission Range Sensor
- Perform the necessary programming and setup procedure: Solenoid Valve Characterization Reprogramming
- Refer to the following: Transmission Range Sensor Duty Cycles
- For the system learn/reset procedure, refer to DTC P0707, P0708, P2802, P2803 or P2805
- For control module replacement, programming and setup, refer to Control Module References