Circuit/System Description
WARNING: This page is about a different variant/trim than selected.
The solenoid actuator controls fluid pressure by moving the clutch 2-9 regulator valve that controls the fluid pressure to the 2-9 clutch.
DTC P0776, P0777 sets only when there is a hydraulic/mechanical problem.
For an overview of the component/system, refer to:
- Park - Engine Running (Hydraulic Circuits)Park - Engine Running (Mechanical Powerflow)
- Reverse (Hydraulic Circuits)Reverse (Mechanical Powerflow)
- Neutral - Engine Running (Hydraulic Circuits)Neutral - Engine Running (Mechanical Powerflow)
- Drive Range, First Gear (Hydraulic Circuits)Drive Range, First Gear (Mechanical Powerflow)
- Drive Range, Second Gear (Hydraulic Circuits)Drive Range, Second Gear (Mechanical Powerflow)
- Drive Range, Third Gear (Hydraulic Circuits)Drive Range, Third Gear (Mechanical Powerflow)
- Drive Range, Fourth Gear (Hydraulic Circuits)Drive Range, Fourth Gear (Mechanical Powerflow)
- Drive Range, Fifth Gear (Hydraulic Circuits)Drive Range, Fifth Gear (Mechanical Powerflow)
- Drive Range, Sixth Gear (Hydraulic Circuits)Drive Range, Sixth Gear (Mechanical Powerflow)
- Drive Range, Seventh Gear (Hydraulic Circuits)Drive Range, Seventh Gear (Mechanical Powerflow)
- Drive Range, Eighth Gear (Hydraulic Circuits)Drive Range, Eighth Gear (Mechanical Powerflow)
- Drive Range, Ninth Gear (Hydraulic Circuits)Drive Range, Ninth Gear (Mechanical Powerflow)