Component Testing
WARNING: This page is about a different variant/trim than selected.
- Ignition/Vehicle - Off
- Remove the component: Transmission Cover
- Disconnect the electrical connector: X1 @ T12 Automatic Transmission Assembly
- Test for 45 to 44000 Ω between the test points: Signal terminal 23 & Low Reference terminal 22
- If not between 45 to 44000 Ω
Replace the component: B13 Transmission Fluid Temperature Sensor
- If between 45 to 44000 Ω
- If not between 45 to 44000 Ω
- Verify the value is within the range listed in the table: Refer to Temperature Versus Resistance
- If not in the specified range
Replace the component: B13 Transmission Fluid Temperature Sensor
- If in the specified range, go to next step
- If not in the specified range
- All OK.