| Front Differential Carrier (238) |
- Inspect for worn wheel bearings or axles.
- Inspect for worn or damaged Side Gear Thrust Washer) or Pinion Gear Thrust Washer
- Inspect for loose or worn Side Gear Axle Splines
- Inspect for damaged or worn Side Gear
- Inspect for worn or damaged Final Drive Inner and Outer Washers
- Inspect for loose, damaged or worn Front Differential Carrier Thrust Bearings
- Inspect for broken, worn or disengaged Final Drive Pinion Pin Retainer
- Inspect for damaged or worn Pinion Gears
|
| Drive Link (233) |
- Inspect for worn, loose or damaged links
- Inspect for broken, worn or loose Drive Link Lubricant Scoop (60)
|
| Drive Sprocket (234) |
- Inspect for improper Drive Sprocket (234) tooth surface finish
- Inspect for broken or damaged Drive Sprocket (234) teeth
- Inspect for worn or damaged Output Sun Gear Thrust Bearings (230)
- Inspect for worn or damaged Output Carrier Transfer Drive Gear Hub Assembly splines (231)
- Inspect for loose, worn or damaged Output Carrier Transfer Drive Gear Hub Assembly bushing
|
| Driven Sprocket (241) |
- Inspect for worn, binding or damaged Driven Sprocket Bearing Assembly (242)
- Inspect for worn or damaged Driven Sprocket Ball Bearing Assembly
- Inspect for improper Driven Sprocket (241) tooth surface finish
- Inspect for broken or damaged Driven Sprocket (241) teeth
|
| Input Carrier Assembly (552) |
- Inspect for pitted/spalled Pinion Gear teeth
- Inspect for worn or damaged Pinion Gear Thrust Washers and Bushings
- Inspect for worn or damaged Pinion Gears, Pins or Needle Bearings
- Inspect for loose or broken Hub and Ring Gear
- Inspect for loose or broken Output Internal Gear Retainer
- Inspect for loose or worn Sun Gear Thrust Bearings (550, 553)
|
| Output Carrier Transfer Drive Gear Hub Assembly (231) |
- Inspect for worn or damaged Pinion Gear Thrust Washers and Bushings
- Inspect for worn or damaged Pinion Gears, Pins or Needle Bearings
- Inspect for loose Hub and Ring Gear
|
| Overdrive and Reaction with Input Internal Gear Carrier |
- Inspect for worn or damaged Pinion Gear Thrust Washers and Bushings
- Inspect for worn or damaged Pinion Gears, Pins or Needle Bearings
- Inspect for loose hub and Ring Gear
- Inspect for worn or damaged Overdrive Sun Gear Thrust Bearing (544)
|
| Automatic Transmission Fluid Pump Assembly (201) |
- Inspect for proper fluid level
- Inspect for leaking Automatic Transmission Fluid Filter Seal (202)
|
| 1-2-3-4-5-6 Clutch |
- Inspect for inadequate Clutch Plate Clearance
- Inspect for stripped or sheared Clutch Plate Splines (595 - 599)
- Inspect for loose or worn 1-2-3-4-5-6 Clutch Backing Plate Retaining Ring (599)
|
| 2-9 Clutch |
- Inspect for inadequate Clutch Plate Clearance
- Inspect for stripped or sheared Clutch Plate Splines (517 - 519)
- Inspect for loose or worn 1-2-3-4-5-6 Clutch Piston Housing Return Ring (523)
|
| 3-8 Clutch |
- Inspect for inadequate Clutch Plate Clearance
- Inspect for stripped or sheared Clutch Plate Splines (513 - 514)
- Inspect for loose or worn 3-8 Clutch Spring Retaining Ring (511)
- Inspect for loose Automatic Transmission Input Shaft Speed Sensor Reluctor Wheel (561) or Retainer (560)
|
| 4th Clutch |
- Inspect for inadequate Clutch Plate Clearance
- Inspect for stripped or sheared Clutch Plate Splines (540 - 542)
|
| 5-7-Reverse Clutch |
- Inspect for inadequate Clutch Plate Clearance
- Inspect for stripped or sheared Clutch Plate Splines (578 - 581)
- Inspect for loose or worn 5-7-Reverse Clutch Backing Plate Retaining Ring (582)
|
| 6-7-8-9 Clutch |
- Inspect for inadequate Clutch Plate Clearance
- Inspect for stripped or sheared Clutch Plate Splines (574 - 576)
- Inspect for loose or worn 6-7-8-9 Clutch Backing Plate Retaining Ring (577)
|
| Automatic Transmission Case (19) |
- Inspect for loose or broken Transmission Mount Bolts
- Inspect for loose Torque Converter and Differential Housing Bolts (16)
- Inspect for loose, worn or damaged differential bushing
- Inspect for loose or broken Input Shaft Support Bolts (55)
- Inspect for loose or broken Front Differential Carrier Baffle Bolts (62)
- Inspect for stripped or sheared splines
- Inspect for loose, worn or damaged bushing
|
| Torque Converter Housing (13) |
- Inspect for loose or broken Front Differential Ring Gear Retainer (206)
- Inspect for loose, worn or damaged differential bushing
- Inspect for loose or broken Pinion Gear Shaft Retainer Pin
- Inspect for loose or broken Front Differential Carrier Baffle Bolts (204)
- Inspect for loose or broken Automatic Transmission Fluid Pump Cover Bolt (200)
- Inspect for loose Torque Converter and Differential Housing Bolts (16)
- Inspect for loose, worn or damaged bushing
|
| Control Valve Body Cover (3) |
Inspect for loose, missing or broken Valve Body Cover Bolts (1) |
| Torque Converter (14) |
- Inspect for improper alignment of Torque Converter to the Crankshaft
- Inspect for ballooning of the Torque Converter
|
| Front Differential Carrier (238) |
- Inspect for worn or damaged Front Differential Carrier (238)
- Inspect for worn or damaged Pinion Pins
- Inspect for broken, worn or damaged Differential Sun Gear Bearing or Driven Sprocket Bearing
- Inspect for worn or damaged Differential Side Gear teeth, Final Drive Pinion Gear teeth or Final Drive Sun Gear teeth
- Inspect for worn or damaged Differential Side Gear Thrust Washers or Final Drive Inner and Outer Washers
- Inspect for worn or damaged Final Drive Rollers
- Inspect for broken or damaged Differential Pinion Gear Shaft Retainer
|