Component Testing
WARNING: This page is about a different variant/trim than selected.
- Test the resistance between the test points:Terminal 1@Q77 Transmission Control Solenoid Valve & terminal 2@Q77 Transmission Control Solenoid Valve. Verify the value is within the range listed in the table: Transmission Solenoid Information
- If not in the specified range
Replace the component:Q77 Transmission Control Solenoid Valve
- If in the specified range, go to next step , go to next step.
- If not in the specified range
- Test for infinite resistance between the test points: Terminal 1@Q77 Transmission Control Solenoid Valve & ground
- If less than infinite resistance
Replace the component: Q77 Transmission Control Solenoid Valve
- If infinite resistance , all OK.
- If less than infinite resistance