LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission - 9T50 (M3E) - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0707, P0708, P2802, P2803 or P2805: Transmission Range Sensor Circuit >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Ignition - On / Vehicle - In Service Mode
  2. Verify DTC P0641, P0651, P0697, P06A3, P2805 is not set.
    • If DTC P2805 is set 

      Replace the component: B303 Transmission Range Sensor

    • If DTC P0641, P0651, P0697, P06A3, P2805 is not set 
  3. Verify the condition does not exist: Incorrect adjustment - Refer to Range Selector Lever Cable Adjustment
    • If a condition exists 

      Repair or replace as necessary.

    • If no condition exists, go to next step 
  4. Operate the component: S3 Transmission Shift Lever - Select each position

    Verify the scan tool parameter: Transmission Range Sensor 1, 2 = The value should be within the range listed in the table: Transmission Range Sensor Duty Cycles

    • If not in the specified range 

      Refer to Circuit/System Testing

    • If in the specified range, go to next step 
  5. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data.

    Verify the DTC does not set.

    • If the DTC sets 

      Refer to Circuit/System Testing

    • If the DTC is not set, go to next step 
  6. All OK.
scientia non olet · About LEMON Manuals