LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2017 >> Malibu LS >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Automatic Transmission - 9T50 (M3E) - Diagnostic Information And Procedures) >> Diagnostic Information and Procedures >> DTC P0711, P0712, P0713: Transmission Fluid Temperature Sensor >> Circuit/System Verification

Circuit/System Verification

WARNING: This page is about a different variant/trim than selected.
  1. Verify the correct fluid level and condition: Transmission Fluid Level and Condition Check 
    • If a condition exists 

      Repair or replace as necessary.

    • If no condition exists, go to next step 
  2. Verify the scan tool parameter: Transmission Fluid Temperature=-39 to 169°C (-38 to 336°F)
    • If not between -39 and 169°C (-38 and 336°F) 

      Refer to Circuit/System Testing

    • If between -39 and 169°C (-38 and 336°F) 
  3. Operate the cold vehicle above 64 km/h (40 MPH) for 10 min.

    Verify the scan tool parameter: Transmission Fluid Temperature=Temperature increases greater than 2°C (4°F)

    • If the temperature does not increase 2°C (4°F) or greater 

      Refer to Circuit/System Testing

    • If the temperature increases greater than 2°C (4°F) 
  4. Operate the vehicle within the Conditions for Running the DTC. You may also operate the vehicle within the conditions that you observed from the Freeze Frame/Failure Records data. Verify the DTC does not set.
    • If the DTC sets 

      Refer to Circuit/System Testing

    • If the DTC is not set, go to next step 
  5. All OK.
scientia non olet · About LEMON Manuals