Section 1679 (Engine Mechanical - 6.6L (LMM) - Repair Instructions - Off Vehicle (3 Of 3))
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
- Valve Rocker Arm, Shaft, and Push Rod Installation
- Valve Clearance Adjustment
- Intake Manifold Installation - Left Side
- Intake Manifold Installation - Right Side
- Intake Manifold Crossover Installation
- Valve Rocker Arm Cover Installation - Lower Left Side
- Valve Rocker Arm Cover Installation - Lower Right Side
- Valve Rocker Arm Cover Installation - Upper Left Side
- Valve Rocker Arm Cover Installation - Upper Right Side
- Fuel Injector Installation
- Fuel Feed Pipe and Fuel Rail Installation
- Turbocharger Installation
- Exhaust Gas Recirculation Valve and Cooler Installation
- Engine Wiring Harness Assembly Installation
- Engine Coolant Thermostat Housing Installation
- Generator and Drive Belt Tensioner Bracket Installation
- Fuel Filter Assembly Installation
- Power Steering Pump Mounting Bracket Installation
- Fan Pulley Installation
- Engine Removal from Stand
- Flywheel Housing Installation
- Upper Oil Pan Installation
- Lower Oil Pan Installation
- Exhaust Pipe Installation - Left Side
- Exhaust Pipe Installation - Right Side
- Exhaust Outlet Installation
- Crankshaft Rear Oil Seal Installation
- Engine Flywheel Installation (Automatic Transmission)
- Engine Flywheel Installation (Manual Transmission)
- Crankshaft Balancer Installation
- Starter Installation
- Engine Prelubing