Exhaust Pipe Installation - Right Side

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exhaust Pipe

Courtesy of GENERAL MOTORS CORP.

NOTE: Position the exhaust pipe gaskets with the tabs as shown. Failure to do so will cause improper alignment of the gaskets and result in exhaust leaks.

Install the exhaust pipe with gaskets.
Install the exhaust outlet bracket.
Install the exhaust pipe to turbocharger bolts.

Fig 2: View Of Exhaust Manifold Bolt Tightening Sequence

Courtesy of GENERAL MOTORS CORP.

CAUTION: Refer to Fastener Caution .

Install the exhaust pipe to exhaust manifold bolts in sequence.
Tighten: Tighten the exhaust pipe bolts to 53 N.m (39 lb ft) in sequence.

Tighten: Tighten the exhaust pipe to EGR cooler nuts to 26 N.m (19 lb ft).