Special Tools
WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
J 45299: Engine Preluber
For equivalent regional tools, refer to Special Tools .
- Remove the engine oil filter, fill with clean engine oil, and reinstall. Tighten the oil filter to 24 N.m (18 lb ft).
- Remove the oil pressure sensor.
- Install the M16 x 1.5 adapter P/N 509375.
- Install the flexible hose to the adapter and open the valve.
- Pump the handle on J 45299: preluber to flow a minimum of 1-2 quarts of engine oil. Observe the flow of engine oil through the flexible hose and into the engine assembly.
- Close the valve and remove the flexible hose and adapter from the engine.
- Install the oil pressure sensor and tighten to 41 N.m (30 lb ft).
- Top off the engine oil to the proper level.
CAUTION:
Refer to Fastener Caution
.
NOTE:
A constant/continuous flow of clean engine oil is required to properly prime the engine. Be sure to use an approved engine oil as specified in the owners manual.