LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Tahoe PPV >> Repair and Diagnosis >> External Pages >> Different car >> Section 1679 (Engine Mechanical - 6.6L (LMM) - Repair Instructions - Off Vehicle (3 Of 3)) >> Valve Rocker Arm Cover Installation - Upper Left Side

Valve Rocker Arm Cover Installation - Upper Left Side

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Upper Valve Rocker Arm Cover & Gasket
    GM1335635Courtesy of GENERAL MOTORS CORP.
  1. Install NEW valve rocker arm cover grommets and use NEW valve rocker arm cover bolts if they are serviced with the grommet.
    2. NOTE: The gasket may be reused if it is not torn, cracked, stretched, or swollen.
  2. Install the upper valve rocker arm cover.
    3. Fig 2: Upper Valve Rocker Arm Cover Bolts Tightening Sequence
    GM1411030Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  3. Install the upper valve rocker arm cover bolts. Tighten the upper valve rocker arm cover bolts to 8 N.m (71 lb in).
scientia non olet · About LEMON Manuals