LEMON Manuals: Even more car manuals for everyone
Home >> Chevrolet >> 2012 >> Tahoe PPV >> Repair and Diagnosis >> External Pages >> Different car >> Section 1679 (Engine Mechanical - 6.6L (LMM) - Repair Instructions - Off Vehicle (3 Of 3)) >> Valve Rocker Arm Cover Installation - Lower Left Side

Valve Rocker Arm Cover Installation - Lower Left Side

WARNING: This page is about a different car, the 2010 GMC Sierra, 2010 GMC Cab & Chassis Sierra, 2010 Chevrolet Silverado, and 2010 Chevrolet Cab & Chassis Silverado. However, it is still accessible from the selected car via links, so may be relevant.
    Fig 1: View Of Lower Valve Rocker Arm Cover (Left)
    GM1335926Courtesy of GENERAL MOTORS CORP.
  1. Install NEW valve rocker arm cover grommets and use NEW valve rocker arm cover bolts if they are serviced with the grommet.
    2. NOTE: The gasket may be reused if it is not torn, cracked, stretched, or swollen.
  2. Install the lower valve rocker arm cover.
    3. Fig 2: Lower Valve Rocker Arm Cover Bolts Tightening Sequence
    GM1411029Courtesy of GENERAL MOTORS CORP.
    CAUTION: Refer to Fastener Caution .
  3. Install the lower valve rocker arm cover bolts.
    1. Tighten the lower valve rocker arm cover bolts in the proper sequence to 10 N.m (89 lb in) .
    2. Retighten the lower valve rocker arm cover bolts in the proper sequence to the same torque, 10 N.m (89 lb in) .
scientia non olet · About LEMON Manuals